The ADR tunnel restriction code is a letter code showing which categories of road tunnel a vehicle carrying a given dangerous good may not enter. The code is given in column 15 of ADR Table A; tunnels are divided into five categories from A to E. For example, petrol has the code (D/E), so a petrol tanker cannot pass through category D and E tunnels.
What are the tunnel categories?
Under ADR 1.9.5, the tunnel category is determined by the competent authority of the country concerned. The assessment is based on three major hazards that could cause loss of life or serious damage to the structure in a tunnel: explosion, release of toxic gas or volatile toxic liquid, and fire. The same tunnel may be in a different category depending on the time of day or the day of the week.
| Category | Restricted hazard |
|---|---|
| A | No restriction |
| B | Substances that may cause a very large explosion |
| C | In addition to B, risk of a large explosion or a large toxic release |
| D | In addition to C, risk of a large fire |
| E | All dangerous goods except those marked “(-)” in Table A |
The category is indicated at the tunnel entrance by a plate with the letter B, C, D or E added below the sign prohibiting entry to vehicles carrying dangerous goods. Category A has no sign.
How are the codes read?
The full code is a list of prohibited categories. In codes with a slash, the letter on the left applies to tank or bulk carriage, and the letter on the right to other carriage.
- B/D: For tank carriage, entry to categories B, C, D and E is prohibited; for packaged carriage, only D and E are prohibited. LPG (UN 1965) has this code.
- C/D: For tank carriage, C, D and E are prohibited; for other carriage, D and E. Anhydrous ammonia and chlorine are examples.
- D/E: For bulk or tank carriage, D and E are prohibited; for packaged carriage, only E. Petrol and diesel are in this group.
- E: Only category E is prohibited. Sulphuric acid, sodium hydroxide solution and acid batteries are examples.
- B1000C, C5000D: For explosives, if the net explosive mass exceeds 1,000 kg or 5,000 kg, the restriction extends to the next higher category.
- (-): No tunnel restriction.
Which loads does it apply to?
Under ADR Chapter 8.6, the restrictions apply to transport units required to display orange-coloured plates. Transport units marked for limited quantities, however, may not enter category E tunnels if the gross mass of the limited-quantity packages exceeds 8 tonnes. If the vehicle carries several substances with different codes, the most restrictive code applies to the whole load. Quantities carried under the ADR 1.1.3 exemptions are not counted. The limits of the exemptions are explained in the entries on limited quantities and transport categories.
How is it written in the transport document?
ADR 5.4.1.1.1(k) requires that, for carriage passing through restricted tunnels, the code be written in capital letters and in brackets at the end of the description of the substance: “UN 1203 PETROL, 3, II, (D/E)”. The UN number, proper shipping name, label number, packing group and tunnel code must be written in this order without any other information in between. Since the route is not always known exactly in advance, most consignors put the code on every document. The other mandatory fields are in the entry on ADR transport documents.
Effect on route planning
- Determine the load's code from ADR Table A; for mixed loads, use the most restrictive code.
- Check the tunnels on the route and their categories against the lists published by the competent authorities of the transit countries.
- If the category changes by time of day, schedule the passage in a suitable time window.
- For a prohibited tunnel, calculate the alternative route including its effect on distance and driving time. In regions with many long tunnels, such as Alpine crossings, this difference can be measured in hours.
- If there is a sea leg, the IMDG Code rules apply on the vessel side.
A common mistake is to check the code for packaged cargo and then use the same tunnel on a trip where the same substance is carried in a tank; with slash codes, the outcome of these two cases is different.
How does Voltim Global support you here?
In dangerous goods transport, Voltim Global prepares the route plan taking the tunnel code, driver rest periods and border crossings into account together. The category of each tunnel in the route plan is matched one by one against the code written in the documents.